Run a speaker timer for a talk and Q&A
For a 12-minute talk followed by three minutes of questions, use two countdown cues. Give the moderator the console and let the presenter watch the read-only screen.
Set the warning before the talk
Set the talk length to 12 minutes and its warning threshold to one minute. Rehearse a shorter copy to check that the display turns amber at the threshold. If sound is wanted, enable sound on the actual display and listen during rehearsal.
Agree on the wrap-up signal
Show the speaker the amber warning before the audience arrives. At the agreed time, send a short screen message such as “Final sentence”. Ask the speaker to confirm they can read it from the lectern.
Hand over to questions
Create a separate three-minute Q&A cue. Leave automatic chaining off when the moderator needs to introduce questions. Enter Run mode on the operator device to lock editing there, then select and start the Q&A cue at handover.
What if the talk runs over?
With chaining off, the countdown can pass zero and show overtime in red. Agree beforehand whether the moderator will shorten questions or accept a later finish. For example, if the talk takes 13 minutes of a fixed 15-minute slot, return to Preparation and set Q&A to two minutes before starting it.